- Crusher Seriers
- Jaw Crusher
- Impact Crusher
- Hammer Crusher
- Cone Crusher
- Compound Crusher
- Ball mill
- Sand Making Seriers
- Sand Making Machine
- Fine Crusher
- Sand Washing Machine
- Vibrating Screen
- Vibrating Feeder
- Belt Conveyor
- Aerocrete Brick
- Cutting Machine
- Autoclave
- Pouring Machine
- AAC Mould
- Equipment Concrete Brick
- Brick Pressing Machine
- Block Making Machine
- SZ-150T concrete brick making machine
- Process
- Sand Production Line
- Stone Production Line
- Aerated Concrete Production Line
- Unburned Brick Production Line
Aerated block cutting machine
Aerated block cutting machine
Aerated concrete as the wall materials innovation and building energy conservation an important component of the practice is a proven alternative to the ideal brick wall material, which in a variety of wall materials with a strong competitive edge. Aerated concrete production equipment is the main filling block cutting machine, therefore, increase the quality of gas block cutting machine with a direct impact on the quality of aerated concrete. I produced gas block cutting machine, using highly intelligent operation and management, as well as centralized control of PLC, frequency converter with the brand to achieve fully automatic operation of the entire cutting process. Moreover, after the body turned upright so that aerated concrete body width 600mm, height of 120 (150) mm, so that makes a shorter cut wire, wire break is not easy, not easy to drift, high precision cutting.
Characteristics of block cutting machine:
1. High efficiency, high precision cutting, high degree of automation;
2. Technology advanced, not the second hoisting, lifting several times reduced due to the injury of the ligand;
3. The structure of compact, simple operation, easy maintenance;
4. The performance of reliable, advanced, and has quick-change wire device;
5. For all the recycling waste, no secondary pollution;
6. Aerated block cutting machine can produce not only plates, but also on the body surface for six cutting, so the quality of finished products from other factors such as oil and die mold deformation;
7. Transection using screw drive, hydraulic transmission to solve the original problem of non-synchronous.
block cutting machine Specification:
| Number | Spec | Front cuts the semifinished materials(mm) | Cycle | Ability (m3/year) | Precision(mm) | Total output(kw) | outlook size(mm) |
| 1 | JQF3.9 | 4050×1240×650 | 6 minutes/ model | The above 100,000 | Six cuts<±2 | 26.5 | 11000×4200×5600 |
| 2 | JQF6.0 | 6050×1540×650 | 6 minutes/ model | The above 100,000 | Six cuts<±2 | 30 | 13200×4600×5800 |
Note: This specification is just for reference, any changes are subject to the products.